User`s manual

BLOWER DUCT APPEARS TO JUMP WHILE OSCILLATING

1. The blower duct may be fastened too tight against the top of the WayCool®. The nut above

the brace should be loosened allowing 1/16” clearance between the bottom of the blower

duct and the top of the WayCool®.

2. If the blower duct is not too tight, the linkage may be damaged. Look for visible damage to

the linkage rod or the lever. If any of the linkage parts are damaged, they will need to be

replaced.

EXCESSIVE NOISE

1. The blower duct may be fastened too tight against the top of the WayCool®. The nut above

the brace should be loosened allowing 1/16” clearance between the bottom of the blower

duct and the top of the WayCool®.

2. If the blower duct is not too tight, the linkage may be damaged. Look for visible damage to

the linkage rod or the lever. If any of the linkage parts are damaged, they will need to be

replaced.

3. A motor bearing may have failed. If the noise is determined to be coming from the motor,

the bearing may have failed and the motor may need to be replaced.

BLOWER DUCT LIFTS UP OUT OF RECESS IN TOP OF UNIT

1. The blower duct may be too loose. There should be approximately 1/16" clearance

between the blower duct and the top of the WayCool®.

2. The linkage may be damaged. Look for visible damage to the linkage rod or the lever. If

any of the linkage parts are damaged, they will need to be replaced.

*WARNING - If the top of the unit is removed for troubleshooting or any other reason, the wires

from the gear motor must be first disconnected from the oscillator switch. This can be done by first

removing the (2) female disconnects that are attached to the back of the switch.

OPTIONAL ACCESSORIES

PNEUMATIC WHEEL OPTION

Pneumatic wheels are available at the time of your WayCool® purchase

or as a retrofit kit on a previously purchased WayCool®.

The pneumatic wheel options includes two locking and two non-locking

wheels.

Pneumatic wheels are designed to allow for easy rolling on rough or

uneven surfaces.