Zubri Portable Heater Propane Gas Heater - 40,000 BTU USER'S MANUAL WARNING Important safety precautions are described in these instructions! They must be read before using the Zubri Z1-12 patio heater or handling gas/propane cylinders. Z1-12 800-779-3267 sales@schaeferfan.com • www.schaeferfan.
Parts Identification Emitter Folding Wing Nut (attached) Spring Clip Emitter Burner Head Threaded Rod Wing Nut & Washer Body U Bracket Legs Gas Valve Gas Regulator Hose Thermocoupler Reflector Skirt Control Cone Knob 2
Z1-12 Assembly Instructions * IMPORTANT NOTE * IF THE REGULATOR HOSE IS NOT CONNECTED INSIDE THE CONTROL CONE, a thin layer of teflon tape should be applied to the threads on the gas valve before attaching the hose to ensure a safe, tight connection. STEP 1 ATTACH LEGS TO CONTROL CONE STEP 2 ATTACH LEG STABILIZER BRACE Depress spring clip on leg and slide leg into leg holder on control cone. Be sure the spring clip locks into hole in leg holder.
Z1-12 Lighting Instructions STEP 1 TURN ON GAS SUPPLY AT PROPANE CYLINDER Off High STEP 2 POSITION FLAME AS SHOWN 4 Ignite STEP 3 PUSH IN CONTROL KNOB AND TURN COUNTER-CLOCKWISETO IGNITE GAS KEEP THE CONTROL KNOB PUSHED IN FOR AT LEAST 15 SECONDS This will allow the thermocouple safety device to heat up. If the thermocouple is not heated correctly the gas supply will automatically be cut off.
Case/Pad Assembly Instructions Top FOLLOW THESE INSTRUCTIONS TO ASSEMBLE A NEW CASE 1 Included in Zubri heater case: Four - V foam pads Two - center foam pads 2 To attach V pads (see Figure 1): 1. Carefully note the location to adhere each pad. Two of the V pads are to be attached approximately one inch below the second indented slots from the top. The other two V pads are to be attached approximately one inch above the fourth indented slots from the top. * DO NOT INSERT PADS INTO THE INDENTED SLOTS.
Safety Guide PLEASE READ THESE INSTRUCTIONS BEFORE USING ANY ZUBRI PATIO HEATER AND KEEP FOR FUTURE REFERENCE. The following paragraph does not apply to any country where such provisions are inconsistent with local law. This publication is provided "as is" without warranty of any kind, either express or implied, including, but not limited to, the implied warranties of merchantability or fitness for a particular purpose.
Safety Guide Cont'd FOR YOUR SAFETY If you smell gas, shut off gas supply to appliance and extinguish open flame. Do not store or use gasoline or other flammable vapors or liquids near this or any other gas appliance. For outdoor use only. Improper installation, adjustment, service or maintenance can cause injury or property damage. Read the safety, assembly, operating and maintenance instructions thoroughly before installing or servicing equipment. • The installation must conform to local codes.
Troubleshooting The most common cause for the heater not working correctly is an inadequate or non-existent gas supply. Therefore, if the heater will not light you should check the following: • There is gas in the cylinder. • The gas valve on the cylinder is fully open. • The quick connectors are firmly fastened together. • You are following the ignition instructions provided on the heater label or in this manual. • The emitter is fastened securely to the burner head. • The emitter is clean.
Storage • Turn off gas supply at cylinder when not in use. • Do not store the heater indoors unless the cylinder has been removed: 1) Unzip the skirt. 2) Turn off gas supply at cylinder. 3) Disconnect the regulator hose from the cylinder. Do not disconnect the hose from inside the control cone. 4) Remove cylinder from the hook. 5) Always replace the safety cap when putting the cylinder into storage to prevent dirt from entering the valve.
800-779-3267 www.schaeferfan.