Assembly instructions Schiller 8-Locks Cur Schiller S-Locks come in a attractive re-usable crystal box that you can use as a storage container after removing the protective foam. Strap bunion with high Le : 5 deride felt washers = 2x Lock Lock-Wheal Assembly of the strap buttons Screw the strap buttons with attached felt washer into the existing holes by hand with a 3mm/1/8" Allen key. If there is still no drill hole, drill this depending on the wood used.
& We recommend choosing the strap:button first to match the size of the existing hole in the guitar. & If the hole is too big or too small, please choose a different strap bunion or reduce / close Zr-drill or extend the hole. = If necessary, countersink separately in the area of the outer lacquer layer to prevent the lacquer from flaking off when screwing in the strap button. ® Carefully screw in the strap button into the wood and, if it is too tight, unscrew it again and gradually drill up the drill hole.
.) Installation of the Lock-Wheels {3-stage safety concept) Turn the lock-whee! clockwise onto the thread of the lock. The flat side must point to the belt; the rounded side up! Make sure that the small set screw in the lock-wheel is not screwed inwards and destroys the thread. Use a mimic/ 5/64” Allen key or small screwdriver through the 2-hole mount for an even tighter fit of the lock-wheel for maximum grip.
Screw in the set screw with a cone tip and slot 2.5x5mm with a screwdriver until it stops. This will lock the thread and the lock wheel will not release. Check the secure seating of the set screw regularly and re tighten the set screw if necessary. To unscrew the lock-wheel, simply loosen the set screw; the thread reaming functional, it cuts through the lock-wheal again “free”.
4.) Function of the S-Locks Pull the lock over the strap button without pulling the ball upwards until the lock clicks into place and the boll lowers into the strap button. The instrument hangs in the U-shaped lock and is thereby held securely. Check the secure fit. To do this, try to pull the lock without pulling the ball from the strap button. The lock must remain engaged and must not be pulled down by the strap button. The ball must sit on top of the thread.
