Operation Manual
18 | EN
line of the character display.
Clock Setting
The clock in this radio is equipped to receive a DAB radio frequency and RDS time signal. After
the unit has been turned on, it will automatically tune into a DAB radio station (see below) and
update the clock. It may be necessary to wait for 1-2 minutes to allow the unit to receive the
time signal. If there is no DAB or FM-RDS reception it will be necessary to manually set the
clock.
To manually set the clock:
1. Power the unit as described above.
2. The display backlight will illuminate for a few seconds, a welcome message (F.1) will
appear in the display briey followed by “00:00:00 Time is not set”.
3. Switch the unit on by pressing the STANDBY button.
4. Press and hold for 2 seconds the MENU/INFO button to enter the menu. Select “System”
by pressing the TUN/CH▲ or TUN/CH▼ button. Once “System” is displayed, press the
SELECT button to enter the system settings.
5. In the system settings select “Time” by pressing the TUN/CH▲ or TUN/CH▼ button.