Operation Manual
EN
EN | 19
Once “Time” is displayed, press the SELECT button to enter the time menu and select
“<Set Time /Date>”. Press the SELECT button again to enter the time setting.
6. The hours are ashing. Set the current hour by pressing the TUN/CH▲ or TUN/CH▼
button. Conrm by pressing the SELECT button.
7. The minutes are ashing. Set the current minute by pressing the TUN/CH▲ or TUN/
CH▼ button. Conrm by pressing the SELECT button.
8. In the next step the date must be set. Set day, month and year by pressing the TUN/
CH▲ or TUN/CH▼ button. Conrm each setting by pressing the SELECT button.
9. Once the year has been set and conrmed by pressing the SELECT button, “Time
Saved” will be shown in the display.
10. You can now exit the menu by repeatedly pressing the MENU/INFO button or switching
the unit into standby mode by pressing the STANDBY button.
DAB+ Radio
First Use and Operation
• Press the STANDBY button to turn the radio on. When switching the radio on for the rst
time it will automatically enter DAB+ mode and perform the auto scan function to search
for available radio stations.
• During the scan the display shows “Scanning...” together with a slide bar that indicates
the progress of the scan and the number of stations that have been found so far (F.1,
F.2).
• Once the scan is nished the radio will select and play the rst alphanumerically found
station.
• You can now press the TUN/CH▲ or TUN/CH▼ button to explore the found stations
followed by pressing the SELECT button to play the selected station.
Note:
• If there are no stations found after auto scan, the radio will enter the Tune/Select menu.
In this menu you can chose to do full scan or manual tuning.
DAB Auto Scan
The auto scan will search for the entire DAB Band III channels. After the scan has nnished, the
rst alphanumerically found stations will be automatically selected.
1. To activate auto scan, press and hold the
MENU/INFO button for 2 seconds to enter the
menu and then press the TUN/CH▲ or TUN/
CH▼ button to select “Full scan”. Finally press
the SELECT button to conrm. The display will
show “Scanning…” and a slide bar (F.3).
2. All stations that have been found will be stored
automatically. To explore the stations that have been found, press the TUN/CH▲ or
TUN/CH▼ button and when you nd a station that you would like to listen to, press the
SELECT button.