Operation Manual
22 | EN
be displayed in the lower half of the display (F.10). If the preset has not been allocated
“Preset Recall #: (Empty)” and then “Preset empty” will be shown in the display.
Note:
• If the unit is disconnected from the mains supply for any length of time and the batteries
are not installed, the programmed stations will be lost.
Factory Reset
If moving the radio to another location in the country the pre-tuned and stored DAB stations may
no longer be available and it will be necessary to reset the radio back to the factory settings.
1. Connect the radio to AC mains (via AC/DC adaptor), then press STANDBY to turn the
radio on.
2. Press and hold the MENU/INFO button for 2 seconds to enter the menu, then press the
TUN/CH▲ or TUN/CH▼ button to select “System”. Press the SELECT button to enter
the system menu.
3. Press the TUN/CH▲ or TUN/CH▼ button to select “<Factory Reset>”. Press the SE-
LECT button to conrm (F.11)
4. The display now shows “Factory Reset <No> Yes”. Press the TUN/CH▲ or TUN/CH▼
button to select “<Yes>” and then press the SELECT button again (F.12) to do the factory
reset.
5. The radio will display “Restarting….” and will then go into standby mode.
Note:
• All stored programmed stations will be lost during reset.
Headphone Jack
A headphone jack is located at right side of the unit. When the unit is powered on and playing
music, you can connect earphones (not included) to the headphone jack for your private listen-
ing. Mind the safety information from page 14 on.
With headphones connected the unit’s speaker is disabled. To listen via the speaker again,
disconnect the headphones.