Operation Manual

EN
EN | 25
only be set when the product is on.
4. To set or change alarm 1, press the ALARM/SNOOZE button once while the unit is in
DAB+ or FM mode, then press the SELECT button (F.10).
5. To set or change alarm 2, press the ALARM/SNOOZE button twice, then press the
SELECT button.
6. To exit the alarm setting mode, press the ALARM/SNOOZE button again.
7. The alarm setup prompts you for the following parameters. Select a value for each
parameter by rotating the SCROLL control and pressing the SELECT button to conrm
and move on to the next parameter.
8. Parameters:
On Time - Hours and minutes
Duration - 15/30/45/60/90 minutes
If the alarm is not cancelled, the product returns to standby after this time period.
Source - Buzzer/DAB/FM
If DAB or FM is chosen as the audio source you will also be prompted to select the last
played station or one of the preset station (if set).
Daily/Once/Weekends/Weekdays
Choose the days on which the alarm is active.
Note: if you choose “Once”, you are prompted to enter the required date.
Volume - Rotate the SCROLL control increase or decrease the volume as desired. This
is the volume the alarm will build up to (initially the alarm sounds at a low volume and
gradually gets louder to the set volume).
Alarm - Off/On
In standby mode, active alarms are indicated by displaying the relevant Alarm 1 and or
Alarm 2 icons.
At the set time, the alarm will sound quietly at rst, then gradually building up to the set
volume.
To turn alarms on or off in standby mode
Press the ALARM/SNOOZE button, the display shows the current alarm status.
To switch the alarms on or off, press the ALARM/SNOOZE button repeatedly to cycle
through four states as shown below (F.11).
To choose the alarm status, press the SELECT button to conrm.
Snooze Function
1. To temporarily silence a sounding alarm, press the ALARM/SNOOZE button once, you
can change the snooze period by repeatedly pressing the ALARM/SNOOZE button.
Snooze periods are 5 or 10 minutes for buzzer mode and 5, 10, 15 or 30 minutes for
radio mode. The radio returns to standby for the set time period with Snooze countdown
displayed. When the countdown reaches 0 (zero) the alarm is triggered again (F.12,