User Manual
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
28
|
GB
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and elec-
tronic equipment (WEEE). This product must be dis-
posed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of
waste equipment may have negative consequences
for the environment and human health due to poten-
tially hazardous substances that are often contained
in electrical and electronic equipment. By properly
disposing of this product, you are also contributing
to the effective use of natural resources. You can
obtain information on collection points for waste
equipment from your municipal administration, pub-
lic waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equip-
ment or your waste disposal company.
16. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic.
Defective components must be disposed of as spe-
cial waste. Ask your dealer or your local council.
15. Troubleshooting
The table below contains a list of error symptoms and explains what you can do to solve the problem if your tool fails to
work properly. If the problem persists after working through the list, please contact your nearest service workshop.
Problem Possible cause Help
Saw blade gets loose after
turning off the motor
Fastening nut tightened insufcient-
ly
Tighten fastening nut, M20 left-handed thread
Motor does not start
Failure main fuse Check the mains fuse.
Extension cable defect Replace the extension cable
Connections on the motor or
switch defect
Have it checked by an electrician
Motor or switch defect Have it checked by an electrician
Wrong rotational direction
Capacitor defect Have it checked by an electrician
Changed phase
Have the polarity of the wall socket changed by
an electrician
No motor output, turns off
automatically
Cross section of extension cable is
too low
See "electric connection"
Overload by dull saw blade Insert a sharpened saw blade
Burns on the cutting surface
Dull saw blade Insert a sharpened saw blade
Wrong saw blade Insert correct saw blade