Instructions
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
27
Positioning/Hanging
• The dimensions of the pump shaft must
be not less than 45 x 45 x 45 cm, in or-
freely.
• The pump can be suspended by the
The pump can be suspended and/or re-
moved using a rope.
• For safe suspension, loop the rope
around two of the holders of the han-
dle (1) and guide it upwards through the
handle (1).
• Never suspend the pump by the hose.
• Immerse the pump in the water to be
sucked in by forming an angle of 45
degrees (to reduce the amount of air
trapped in the pump body). If the pump
• Make sure that there are no people in
the liquid to be pumped.
• Connect the pump to the mains.
Adjustment of the oat switch
• -
mediate commissioning is possible.
For stationary installation the function
regularly (at least every three months).
• The ON and OFF switching point of the
-
following points before start of opera-
tion.
•
that the switching point ON level and
the switching point OFF level can be
reached easily and with little expendi-
ture of energy.
• Screw the pump connection angle (6)
onto the pump connection (8).
• Screw the connecting branch for hose
(7) onto the pump connection angle (6).
• Put the hose over the connecting
branch for hose (7) and fasten it with a
hose clamp. Alternatively, use a screw
connection on the pump connection an-
gle (6) or on the connecting branch for
hose (7).
Fitting oat switch (g. 1, 4)
•
• -
ly on the bottom of the shaft or hung up
safely.
• Check whether the pressure line has
been attached correctly and the un-
used pump outlet is fully closed.
• Avoid that the pump runs dry.
• Check that the electrical connection is
220V - 240V ~ 50Hz
• Check the proper status of the electri-
cal plug socket and make sure that the
6 A). Insert the pump plug into the plug
socket and the pump is ready for oper-
ation.
• Make sure that moisture or water nev-
er come in contact with the mains con-
nection.
• There is a risk of electrocution.
9. Initial operation
m IMPORTANT!
You must fully assemble the appliance