Instructions
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
28
|
GB
Such damaged electrical connection ca-
bles must not be used and are life-threat-
ening due to the insulation damage.
Check the electrical connection cables
for damage regularly. Make sure that the
connection cable does not hang on the
power network during the inspection.
Electrical connection cables must comply
with the applicable VDE and DIN provi-
sions. Only use connection cables with
the marking „H05RN-F“.
10. Cleaning, maintenance
and storage
Cleaning
Attention!
Always unplug the power cord before
cleaning.
General cleaning instructions
• In case of transport for utilization in
cleaned with clear water after every
use.
• In case of stationary installation, the
checked regularly (at the latest every
three months).
•
particles which are possibly present in
the pump casing
• Regularly remove sludge from the pit
base (at the latest every 3 months) and
also clean the shaft walls
•
with clear water,
• Check this by placing the pump into a
switch carefully by hand and then low-
er it again. In this case, you can see
• Also ensure that the separation dis-
-
nism is not too small. In the case of a
separation distance which is too small,
trouble-free functioning cannot be
guaranteed.
•
• Attention! Risk of running dry and dam-
age to the device.
Electrical connection
The electrical motor installed is connect-
ed and ready for operation. The connec-
tion complies with the applicable VDE
and DIN provisions.
Damaged electrical connection cable
The insulation on electrical connection
cables is often damaged.
This may have the following causes:
• Passage points, where connection ca-
bles are passed through windows or
doors.
• Kinks where the connection cable has
been improperly fastened or routed.
• Places where the connection cables
have been cut due to being driven over.
• Insulation damage due to being ripped
out of the wall outlet.
• Cracks due to the insulation ageing.