User Manual

Form 55005 Rev. D

12-02-20024

CM5500 COMPUTER MANAGED MORTISE LOCK

INSTALLATION MANUAL

3. CHANGE HAND (IF NECESSARY):

NOTE: The locks are shipped as ordered from factory. If it is

necessary to change the hand of the lock, follow the steps

below:

TO CHANGE HAND OF LOCK CASE:

A. With bolt fully extended, insert change pin (included in the

hardware pack) into hole. (It will snap over a groove on the

main shaft, holding it in place.)

B. Remove set screw in bolt so bolt can be removed.

C. Rotate bolt and reinstall on to shaft. Do not remove spring.

D. Apply thread locking compound to set screw.

Loctite 242 recommended.

E. Install and tighten set screw (from other side, as shown).

F. Remove change pin.

5/32” SOCKET CAP SCREW

LOCTITE 242 RECOMMENDED

OUTSIDE ESCUTCHEON

ADAPTER

LEVER

OUTSIDE HANDLE

CHANGE PIN

LOCK CASE

BOLT

(AUTOBOLT SHOWN)

TO CHANGE HAND OF LEVERS:

A. Loosen 5/32” socket cap screw and remove lever.

B. Rotate handle to opposite position.

C. Apply thread locker to screw. Loctite 242 recommended.

D. Reinstall handle.

E. Repeat for inside escutcheon (not shown).

NOTE:

Some lever designs

require an adapter.