Other Content

5
Manual Programming Functions
Press the keys on the keypad as shown in the following steps. Wait for the confirmation indicator before proceeding to the next step. If
you make a mistake, wait for all lights and beeps to stop and then start over from the beginning.
Add
Press
(Six
Numbers)
Wait For
3 Lights + 3 Beeps
Press
Wait For
3 Lights + 3 Beeps
Press New
(Four
Numbers)
Wait For
3 Lights + 3 Beeps
Press Same New
(Four
Numbers)
Success!
1 Long Light + 1 Long Beep
Delete
Press
(Six
Numbers)
Wait For
3 Lights + 3 Beeps
Press
Wait For
3 Lights + 3 Beeps
Press Unwanted
(Four
Numbers)
Wait For
3 Lights + 3 Beeps
Press Same Unwanted
(Four
Numbers)
Success!
1 Long Light + 1 Long Beep
Change
Press
(Six
Numbers)
Wait For
3 Lights + 3 Beeps
Press
Wait For
3 Lights + 3 Beeps
Press New
(Six
Numbers)
Wait For
3 Lights + 3 Beeps
Press Same New
(Six
Numbers)
Success!
1 Long Light + 1 Long Beep
Enable Vacation
Mode
(Disable All)
Press
(Six
Numbers)
Wait For
3 Lights + 3 Beeps
Press
Success!
1 Long Light + 1 Long Beep
Disable Vacation
Mode
(Enable All
1
)
Press
(Six
Numbers)
Success!
1 Long Light + 1 Long Beep
Enable/Disable
Beeper
Press
(Six
Numbers)
Wait For
3 Lights + 3 Beeps
Press
Success!
1 Long Light + 1 Long Beep
Delete All
2
Press
(Six
Numbers)
Wait For
3 Lights + 3 Beeps
Press
Wait For
3 Lights + 3 Beeps
Press
(Six
Numbers)
Success!
1 Long Light + 1 Long Beep
Enable/Disable
3
Turn Lock Feature
Press
(Six
Numbers)
Wait For
3 Lights + 3 Beeps
Press
Success!
1 Long Light + 1 Long Beep
Put Lock in
Enrollment Mode
4
Press
(Six
Numbers)
Wait For
3 Lights + 3 Beeps
Press
Success!
Blinking
1 Enable All User Codes function is available only when user codes are currently disabled.
2 Delete All User Codes function will remove ALL user codes, but will not change the programming code. User Codes cannot be recovered after this function is completed.
3 The Turn Lock Feature is available only on the BE369 (deadbolt). When this feature is disabled, a valid user code must be entered in order to lock the lock from the
outside. The Turn Lock feature is enabled by default.
4 Bridge must be put into enrollment mode before lock for successful enrollment/exclusion.