User's Manual

8
ENGLISH
Powering the Alarm
The alarm is turned off by default. After installation, you’ll need to turn on your alarm.
 Program the alarm using the Inside Schlage Button, shown below.
 Not sure your alarm is turned on? Simply press the Inside Alarm Button
once. It will beep and light up to confi rm it is activated. If it does not,
try turning the alarm on again, and check the batteries.
 For videos and more, browse to alarm.schlage.com.
Turn the Alarm
ON
Press and hold
Release after fi rst fl ash
(about 5 seconds)
Turn the Alarm
OFF
Press and hold
Release after second fl ash
(about 6 seconds)
Adjusting the Sensitivity Level
The lock comes preset to a sensitivity level of three. If your alarm is sounding too frequently,
or not frequently enough, try changing this setting.
 You do not need to adjust this setting unless the alarm is sounding too frequently or not
frequently enough.
Press and hold
Click the button until the number
of fl ashes matches your desired
sensitivity setting.
Release after third
fl ash (about 10
seconds).
1 - 5 Flashes
 As you cycle through the fi ve levels, the alarm will beep
the same number of times as each setting level.

1
2
3
4
5
1 2 3 4 5
Sensitivity
Level/Beeps
LOW HIGH
PROGRAMMING THE ALARM