User Manual

Schlage Lock Company Responsibilities to comply with FCC and Industry Canada Regulations
The COMAD400V2 900 MHz Communications Board Module has been certified for integration into products
only by Schlage Lock Company under the following conditions:
1. The antenna(s) must be installed such that a minimum separation distance of 20cm is maintained
between the radiator (antenna) and all persons at all times.
2. The transmitter module must not be co-located or operating in conjunction with any other antenna or
transmitter.
As long as the two conditions above are met, further transmitter testing will not be required. However Schlage
Lock Company is still responsible for testing their end-product for any additional compliance requirements
required with this module installed (for example, digital device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions cannot be met (for certain configurations or co-
location with another transmitter), then the FCC and Industry Canada authorizations are no longer
considered valid and the FCC ID and IC Certification Number cannot be used on the final product. In
these circumstances, Schlage Lock Company will be responsible for re-evaluating the end product
(including the
transmitter) and obtaining a separate FCC and Industry Canada authorization.
End Product Labeling
The COMAD400V2 900 MHz Communications Board Module is labeled with its own FCC ID and IC
Certification Number. If the FCC ID and IC Certification Number are not visible when the module is installed
inside another device, then the outside of the device into which the module is installed must also display a
label referring to the enclosed module. In that case, the final end product must be labeled in a visible area with
the following:
“Contains Transmitter Module FCC ID: XPB-COMAD400V2”
“Contains Transmitter Module IC: 8053B-COMAD400V2”
or
“Contains FCC ID: XPB-COMAD400V2”
“Contains IC: 8053B-COMAD400V2”
Schlage Lock Company, the OEM integrator of the COMAD400V2 900 MHz Communications Board module
must only use the approved antenna(s) listed above, which have been certified with this module.
Schlage Lock Company is aware not to provide information to the end user regarding how to install or remove
this RF module or change RF related parameters in the user manual of the end product.
The user manual for the end product must include the following information in a
prominent location:
“To comply with FCC and Industry Canada RF radiation exposure limits for general population, the antenna(s)
used for this transmitter must be installed such that a minimum separation distance of 20cm is maintained
between the radiator (antenna) and all persons at all times and must not be co-located or operating in
conjunction with any other antenna or transmitter.”