User's Manual

B Install strike and magnet tray assembly.
Note: If dustbox is included, install rst.
CAUTION
Magnet tray and included strike must
be installed! DO NOT DISCARD!
ANSI Strike
OR
T-Strike
See instructions below for
magnet installation.
Actual Size
Actual Size
2”
(50mm)
Drill a hole C\v” (19 mm) diameter, 1Z\x” (38 mm) deep
Door Thickness Adjustment
For 1B\,” or 2” thick doors, complete the following door thickness
adjustment steps.
L For 1C\v” thick doors, NO ADJUSTMENT IS REQUIRED.
Continue to step 3.
A Remove chassis from outside assembly.
Pull lever post and rotate 10 degrees counter-clockwise until
adjustment plate tabs align with cutouts on assembly, then remove
chassis from escutcheon.
B Remove adjustment plate and door thickness insert.
C Reorient and replace door thickness insert.
Door Thickness Door Thickness Insert
1B\,”
2”
Door thickness
insert channel
Chassis Side View