User's Manual

Lever Removal
To remove a lever with a
cylinder, insert key rst, and
turn it 90 degrees toward door
edge. Press pin wrench into
hole in lever, and pull off.
To remove a lever without a
cylinder, press pin wrench into
hole in lever, and pull off.
Cylinder and Lever Installation
Lever With Standard Cylinder
Rotate cam in lever
post until the cam
stops.
Insert cylinder into
lever, then insert key.
Rotate the key as
shown.
90˚
LH
90˚
RH
90˚
LH
90˚
RH
Install lever.
Lever With Interchangeable Core Cylinder
Install cylinder
tailpiece.
Rotate cam in lever
post until the cam
stops.
Insert key into
cylinder and insert
into lever. Rotate
the key clockwise 15
degrees.
Install lever.
Non-keyed Lever
Press lever onto lever post.
Continue to User Guide to capture lock with your mobile device.
CAUTION
Door position MUST be calibrated
using the mobile application!