Installation Guide

12
ENGLISH
10b Install the battery cover.
Speaker Hole
DO NOT install screw!
11 Set up the Lock.
1. Open the door if it is not already open.
2. Press the Outside Schlage Button.
3. Enter one of the default access codes into the
lock (see label shown in step 6
on page 5).
4. The lock will perform a setup routine. Wait until
the bolt stops moving before continuing.
»
If the Touchscreen did not light up during this
step, you may have a power problem. Install
fresh batteries and make sure the battery wires
are connected (see step 10a on page 11).
If that does not help, make sure the cable is
connected and is not crimped (see step 9b on
page 10).
12 Test the Lock.
CAUTION
Keep the key with you during
testing to avoid being locked out!
»
For complete information about
programming and light/beep patterns,
see the Manual Programming Guide
and Troubleshooting sections in the User
Guide.
12a Extend the bolt (lock) using the inside thumbturn.
1. Close the door.
2. Rotate the thumbturn toward the door jamb to extend
the bolt.
Was this operation smooth?
Continue to
step 12b.
You may need to adjust your door/
frame. Continue to step 12b for
further testing, or go to answers.
schlage.com and watch the video
Proper Alignment of Door and
Frame for a Smoothly Operating
Lock for adjustment instructions.
NOYES