Installation Guide

9
ENGLISH
8b Install the Support Plate on the inside of the door.
»
Make sure the Touchscreen and Support Plate are straight on the door before
tightening the screws. Tighten screws fully to prevent the lock from moving over time.
TOP
Make sure the indented
circle is facing the door.
Hold the Touchscreen on
the outside of the door
while you tighten the
screws.
Actual Size (2)
TOP
Route the cable
through the slot.
9 Install the Alarm Assembly.
9a Remove the battery cover from the Alarm Assembly.
DO NOT remove
the battery tray
(not shown)!
ELECTROSTATIC DISCHARGE
WARNING!
Touching the circuit board
may damage the lock!