Installation Guide
13
ENGLISH
10b Install the battery cover.
Speaker Hole
DO NOT install screw!
11 Set up the Lock.
1. Open the door if it is not already open.
2. Press the Outside Schlage Button.
3. Enter one of the Default Access codes into
the lock (see label shown in step 6
on page 5).
4. The lock will perform a setup routine. Wait
until the bolt stops moving before continuing.
»
If the Touchscreen did not light up during
this step, you may have a power problem.
Install fresh batteries and make sure the
battery wires are connected (see step
10a on page 11). If that does not help,
make sure the cable is connected and is not
crimped (see step 9b on page 10).
12 Test the Lock.
CAUTION
Keep the key with you during
testing to avoid being locked out!
»
For complete information about
programming and light/beep
patterns, see the Programming the
Touchscreen and Troubleshooting
sections in the User’s Guide.
12a Extend the bolt (lock) using the inside thumbturn.
1. Close the door.
2. Rotate the thumbturn toward the door jamb to
extend the bolt.
Was this operation smooth?
Continue to
step 12b.
You may need to adjust your
door/frame. Continue to step
12b for further testing, or go to
answers.schlage.com and watch
the video Proper Alignment of
Door and Frame for a Smoothly
Operating Lock for adjustment
instructions.
NOYES
12b Extend the bolt (lock) using the Touchscreen.
1. Unlock the door using the thumbturn if you have
not already.
2. Take the key and the Default Access codes with you!
Go outside and close the door.
3. Press the Outside Schlage Button.
4. The bolt should extend.
Alignment is
correct.
You need to adjust
your door/frame.
Go to
answers.schlage.com
for adjustment
instructions.
YESNO
The lock has both a low power and
high power mode. It will try low
power first and then high power when
unsuccessful. Aer three times using
high power, it will always use the high
power mode instead of trying twice
each time. You may want to adjust
your door/frame to conserve battery
power, but it is not necessary.
YES
NO
Did the bolt extend (is the door locked)?
Did the bolt take two tries
to extend?
Each try sounds like two
cycles.
12c Retract the bolt (unlock) using the Touchscreen.
1. Press the Schlage button.
2. Enter one of the default Access codes into the lock.
3. The bolt should retract.
Alignment is
correct.
Use the key to unlock the
door. You need to adjust
your door/frame. Go to
answers.schlage.com
for adjustment
instructions.
YES
NO
Did the bolt retract (is the door unlocked)?
12d If the lock failed to lock or unlock:
1. If the Touchscreen did not light up, you may have a power problem. Install fresh
batteries and make sure the battery connector is connected (see step 10a on
page 11). If that does not help, make sure the cable is connected to the Alarm
Assembly and is not crimped (see step 9b on page 10).
2. If the lock had power but you need to adjust your door/frame, please go online to
answers.schlage.com for complete adjustment instructions and videos.