User Guide

4
CO-100 Offl ine Lock User Guide
GETTING STARTED
Follow these steps when setting up a new lock.
1. Install the lock. See the installation guide that came with the lock, or visit
www.schlage.com/support, for more information.
2. Test the lock for proper mechanical and electronic operation. See Test Lock Operation on page 8
for more information.
3. When ready to set up for normal use, enter a new programming code, then program the user
credentials. See Manual Lock Programming on page 5 for more information.
4. Familiarize yourself with the information in this guide.
!
Save this user guide for future reference.
CONSTRUCTION ACCESS MODE
Construction Access Mode is used to allow access before the lock has been programmed, and for
testing purposes. Construction Access Mode is enabled by default.
Offl ine locks with keypads have a default PIN of 13579
and “#”, which can be used for installation, testing and
construction access.
• To test, enter the default PIN (13579 and “ # ”).
• The Schlage button will blink and the lock will unlock.
• The default PIN is automatically deleted when a new
programming credential is created.
TIP
If you press the Default PIN code on a
new lock and the code is not accepted,
the lock has already been programmed.
If the new PIN is not known, or to put
the lock back into construction access
mode, reset the lock to factory settings.
See Reset To Factory Defaults on
page 10 for more information.