User Guide

6
CO-100 Offl ine Lock User Guide
Manual Programming Commands
Commands are confi rmed by fi ve alternating green blinks of the Schlage button.
Programming mode will time out if no entry is made in 20-25 seconds. Timeout is indicated by red
blinks of the Schlage button, three left and nine right at the same time.
The right LED on the Schlage button will blink green to indicate an incorrect entry. To interpret
blink patterns, refer to Error Codes on page 7.
Function Press
Wait For
Confi rmation
1
Change
[Programming Code]
[Programming Code]
Wait for
to stop flashing
between each
step.
New [Programming Code]
New [Programming Code]
Add Normal Use
PIN
[Programming Code]
Wait for
to stop flashing
between each
step.
New [PIN]
add another PIN OR
to finish
Add Toggle PIN
[Programming Code]
Wait for
to stop flashing
between each
step.
New [PIN]
add another PIN OR
to finish
Add Freeze PIN
[Programming Code]
Wait for
to stop flashing
between each
step.
New [PIN]
add another PIN OR
to finish
Add Pass-Through
PIN
[Programming Code]
Wait for
to stop flashing
between each
step.
New [PIN]
add another PIN OR
to finish
Delete a PIN
[Programming Code]
Wait for
to stop flashing
between each
step.
[PIN] to be deleted
to finish
Change Relock
Time
[Programming Code]
Wait for
to stop flashing
between each
step.
Each button press adds to the total delay time
Example: + adds a 10 second delay
to finish
1 Other lights may show before the fi nal confi rmation. Wait for fi nal confi rmation before continuing to the next step.
2 Change PIN length is available with fi rmware version 2.5.0 or higher.