User Guide

10
CO-200 Offl ine Lock User Guide
TEST LOCK OPERATION
If you encounter problems while performing any of the following tests, review the installation guide
and correct any problems.
Mechanical Test
1. Rotate the inside lever or depress the push bar to open the door. Operation should be smooth,
and the latch should retract.
2. Insert the key into the keyway and rotate the key and the outside lever to open the door.
Operation should be smooth, and the latch should retract.
Test in Factory Default Mode
1. For locks with a keypad, press any number key. The lock will beep and the Schlage button will
blink.
2. The Schlage button will blink red twice when a credential is presented and the lock is in factory
default mode, and has no access programming.
3. For locks with keypads, enter the default PIN (13579 and “#”) to verify access. The Schlage button
will blink and the lock will unlock.
Test in Normal Operation Mode
1. Present a valid credential. The Schlage button will blink green, a beep will sound and the door
will unlock for the preset lock delay period. The lock will re-lock after the lock delay period and the
Schlage button will then blink red.
2. If an invalid credential is presented, the Schlage button will blink red, a beep will sound and the
door will not unlock.
NORMAL LOCK OPERATION
After credentials have been programmed, present credentials to operate the lock as follows:
Credential Type Action
Credential Present credential to reader  Green blink and access granted
+ PIN Credential
Present credential
to reader 
Press PIN
1

Within 5 seconds,
Press
2

Green blink and
access granted
1 If the PIN is entered incorrectly, press “
*
” to start over.
2 The “#” key is used as ENTER key for PINs with fewer than the minimum number of digits. Default minimum digits
is six (6). This can be confi gured with the SUS, so users do not have to push the “#” key.