User Guide

13
CO-200 Offl ine Lock User Guide
LED REFERENCE
Most LED indicators are confi gured with the SUS. See SUS User Guide for more information.
Schlage Button
Condition Lights
Access denied 2 red blinks
Access denied, user outside time zone 4 red blinks
Factory default reset One-second solid green with one-second beep
Waiting for PIN Mode 0 only: 5 left red with right green blinks,
then solid right green
Low battery indicator, AA batteries 9 left red blinks
Low battery indicator, coin cell battery 9 right red blinks
Momentary unsecured access 1 green blink, then one red blink on relock
USB active with no physical connection Left green blinking
An incompatible reader is on the lock
4
3 red blinks and beeps with each card or key
press, or 5 red blinks and 5 beeps on power-up
Optional Inside Push Button (IPB)
Action Lights
Offi ce Mode –Allows lock to toggle between locked (normal) and unlocked state
Press IPB to lock 1 red blink
Press IPB to unlock
1
1 green blink
Privacy Mode – Allows the lock to toggle between normal access and a state in which normal
credentials are ignored
With door closed, press IPB to engage privacy
2
4 green blinks
With door closed, press IPB to release privacy
3
4 red blinks
1 Unlocking the lock with the IPB will cause the lock to remain unlocked until the IPB is depressed again.
2 On locks confi gured with a mortise-deadbolt, throwing the deadbolt will also engage privacy.
3 If DPS is used, then opening door will also release privacy. If a mortise-deadbolt is used, then retracting the
deadbolt will also release privacy.
4 If a reader is replaced, it must be an identical type reader (i.e., magswipe replaced with magswipe), and
Factory Default Reset must be performed after replacement. See Reset To Factory Defaults on page 11 for more
information.