User Guide

15
CO-200 Offl ine Lock User Guide
Problem Possible Cause Solution
The LEDs and beeper
indicate a replaced
and/or incompatible
reader (3 red blinks
and 3 beeps with each
card or key press, or 5
red blinks and 5 beeps
on power-up).
The reader is not the
original reader matched
with the lock at the factory.
If the reader was replaced, check that
the new reader is an identical type to the
original reader (i.e., replace magswipe with
magswipe).
After an identical type reader has been
replaced, the lock must be reset to factory
defaults to match the new reader with the
lock. See Reset To Factory Defaults on page
11 for more information.
If a non-identical type reader has been
installed on the lock, then the original reader
must be reinstalled, or a new identical type
reader must be installed and the lock reset
to factory defaults to match the new reader
with the lock. See Reset To Factory Defaults
on page 11 for more information.