User Guide

14
ENGLISH
FACTORY DEFAULT RESET
When should you perform a Factory Default Reset?
If you want to move the lock to a different door, you need to restore default
settings, move the lock to the new door, and then set up the lock again.
If you have forgotten your Programming Code, you can restore the default codes.
If you have set up your lock using the mobile app, and would like to force the lock
to unpair from all mobile devices, erase all codes, and restore the factory default
settings and default codes.
WARNING
Locate the default Programming and access codes on the front of this guide
or the back of the Alarm Assembly before beginning! Default Programming
and access codes will be restored. All existing access codes and current
Programming Code will be erased.
CUSTOMER SERVICE CANNOT RETRIEVE LOST DEFAULT CODES! DO NOT
RESTORE FACTORY SETTINGS UNLESS YOU CAN LOCATE THE DEFAULT
CODES. See Setup Code and Default Access Codes on page 4.
Using the app, delete the lock. The app will attempt to
return the lock to factory default settings. If successful, the
touchscreen will flash the green check mark. Continue to step
5 below.
1. Disconnect the batteries. See Replacing
the Batteries on page 6.
2. Press and hold the Outside Schlage
Button.
3. While holding the Outside Schlage
Button, reconnect the batteries.
4. Release the Outside Schlage Button.
L If you are moving the lock to a new
door, install the lock on that door
before continuing.
5. To check that the lock was reset, press
the Outside Schlage Button and enter
one of the default access codes. See
Setup Code and Default Access Codes
on page 4.
6. If the reset was successful, the lock will
perform a setup routine. Wait until the
bolt stops moving. The reset and setup
are complete.
EMERGENCY KEY OVERRIDE
Emergency Key Override can be used
when the battery is completely dead, or
when no valid access code is known.
Insert key and rotate to unlock, just like
any lock. See Replacing the Batteries
on page 6.
This lock may be rekeyed to match other
locks in a residence. Contact a locksmith
for assistance.