User Guide

7
ENGLISH
Use the app to easily program your lock!
NOTE: Existing access codes will be deleted when you configure
your lock with the app!
Schlage recommends using the Schlage Sense mobile app to program your lock.
If you don’t have the Schlage Sense app, you can use the manual programming
instructions below.
WARNING
Manual programming functions are NOT available
aer pairing using the mobile app! You must perform a
Factory Default Reset to program your lock manually.
Outside Schlage
Button
• The first button
you will press in the
programming process.
• Can also be pressed
to exit programming
immediately.
Green Check Mark
• Blinks when a number
key is pressed and
when a function is
complete.
Red X
• If there is a problem
during programming,
you will see the red
error X.
Programming
Indicator
• Blinks when
Programming Mode
is entered.
• Solid while a
programming
function is being
performed.
Programming Descriptions
Add Access Code
Access codes unlock the deadbolt. Can be 4 - 8 digits long.
All codes must be the same length. See Adding Access
Codes below.
Delete Access Code
Removes one access code at a time.
Change
Programming Code
The Programming Code is used to put the lock into
Programming Mode. It is 6 digits long.
Enable/Disable
Beeper
The beeper can be turned off if desired. Beeps will still
sound during programming.
Delete ALL Access
Codes
Removes ALL access codes from the lock.
Enable/Disable
1-Touch Locking
When enabled: Press the Outside Schlage Button to lock
the deadbolt. (Default setting).
When disabled: Press the Outside Schlage Button and then
enter an access code to lock the deadbolt.
Change Access
Code Length
Access codes can be 4 - 8 digits in length. Default is 4
digits. Changing the access code length will delete all
existing access codes!
Enable/Disable
Auto-Lock
When enabled, the lock will automatically relock 30
seconds aer unlocking. (Disabled by default.)
Temporarily
Disable
Auto-Lock
Auto-Lock must already be enabled. While the deadbolt is
locked, press the Outside Schlage Button and then enter
a 4-8 digit access code to unlock the deadbolt. Within 5
seconds, manually lock and unlock the deadbolt using the
thumbturn.
Restore
Auto-Lock
Lock the deadbolt using the thumbturn.
MANUAL PROGRAMMING GUIDE