User Guide User Manual
INSTRUCTIONS
Programming Your Alert Setting
The alarm comes pre-set to the Forced
Entry setting and is ready to use. If you
want to change it from Forced Entry
to another alert setting, follow these
simple steps:
1. Press the Schlage button for 2 seconds until
it ashes. After you let go, the alarm will beep.
(When the alarm rst turns on, the light on
the right side of the LED track will ash to
indicate it is in the Forced Entry Alert.)
2. Continue tabbing the Schlage button to
cycle through the different alert settings:
LEFT LED LIGHT: Activity Alert
MIDDLE LED LIGHT: Tamper Alert
RIGHT LED LIGHT: Forced Entry Alert
6