Installation

Connect wire and battery.
7
Lock will beep when
battery is connected.
Place battery in holder and tuck wires.
8
Route wires behind curved
piece and tuck, using tabs, so
they will not be pinched by the
cover.
Tabs
Curved Piece
Install cover.
9
Actual Size
If needed, switch levers.
10
Correct
Incorrect
a b
c
d
If your lever looks like this,
then no change is necessary.
If your lever does not look
like this, switch the levers by
following the steps below.
OR
Insert the pin wrench
into the hole in the
lever. Push in and
hold.
Pull the lever off. Repeat steps a and b to remove the
lever from the other side of the door.
Switch the levers.
Push each lever back
into place.