User's Manual

Installation
2-6 CENTRON Meter Technical Reference Guide
7 Replace the board-to-board connector by aligning the top of the connector
with the notches in the circuit board (see Figure 2.6) and pressing gently at the
bottom of connector to mate the connector to metrology board (see Figure
2.7). Then, gently press the top of the connector to mate it to the register
module (see Figure 2.8). The connector is seated correctly when you hear it
snap into place.
Figure 2.6 Circuit Board Notches
Figure 2.7 Board-to-Board Connector, Bottom
Notches (2)
Be sure to use the meter base for leverage instead of the LCD holder (see Figure 2.7). Pressure
on the LCD holder may damage the personality module.