User's Manual

iv
Factory Repair of Meters
SchlumbergerSema recommends that all repairs be performed at the factory. Certain repairs
may be performed by the user; however, unauthorized repairs will void any existing war-
ranty. All surface mounted parts must be replaced by the factory.
Repair of Meters Under Warranty
If the meter is under warranty, then SchlumbergerSema will repair the meter at no charge if
the meter has failed due to components or workmanship. A return authorization number
must be obtained before the equipment can be sent back to the factory. Contact your
SchlumbergerSema Sales Representative for assistance.
Repair of Meters Not Under Warranty
The same procedure as above applies. SchlumbergerSema will charge for the necessary
repairs based on the failure.
Service Return Address
SchlumbergerSema
Customer Repair Department
313 North Highway 11 Dock C
West Union, SC 29696
ATTENTION
The product you have purchased contains a battery (or batteries), circuit boards,
and switches. The batteries are recyclable. At the end of the meter’s useful life,
under various state and local laws, it may be illegal to dispose of certain
components into the municipal waste system. Check with your local solid waste
officials for details about recycling options or proper disposal.
This equipment generates, uses, and can radiate radio frequency energy. If not installed and
used in accordance with the instructions manual, this equipment can cause interference to radio
communications. The equipment has been tested and found to comply with the limits for a Class
A computing device pursuant to FCC Part 15, Class A registration of FCC Rules, which are de-
signed to provide reasonable protection against such interference when operated in a commercial
environment. Operation of this equipment in a residential area may cause interference in which
case the user will be required to correct the interference at his own expense. The user is encour-
aged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
Consult the dealer or an experienced radio/TV technician for help