Installation Guide

TESTING & CERTIFICATIONS 23
Certifications and listings may be accessed
via our website at www.schluter.com
Certifications
Heating cables
The DITRA-HEAT-E-HK heating cables sets are certified or listed to the following standards and usage:
• CAN/CSA-C22.2 No. 130-03 "Requirements for Electrical Resistance Heating Cables and Heating Device Sets" under usage
markings GXW for general use (G) with a wet rating (W), but specifically (X) for embedded indoor floor warming applications.
• UL 1673 "Electric Space Heating Cables" for installation in poured masonry floors within enclosed structures.
• ANSI/IEEE 515.1-2005 "IEEE Standard for the Testing, Design, Installation, and Maintenance of Electrical Resistance Heat Tracing
for Commercial Applications" for installation Type C embedded floor warming within enclosed structures.
Thermostat
The DITRA-HEAT-E-RSD digital thermostat is:
• Certified to CSA C22.2 No. 24-93 (Reaffirmed 2003) “Temperature-Indicating and Regulating Equipment”.
• Listed to UL 873 “Temperature-Indicating and Regulating Equipment” 11
th
Edition, containing revisions through and including April
18
th
, 2006.
The DITRA-HEAT-E-RT/-R digital thermostats are UL listed according to the following standards:
• UL 60730-1 “Automatic Electrical Controls for Household and Similar Use – Part 1: General Requirements”
• UL 60730-2-9 “Automatic Electrical Controls for Household and Similar Use – Part 2-9: Particular Requirements for Temperature
Sensing Controls”
• CSA E60730-1:13 “Automatic Electrical Controls for Household and Similar Use – Part 1: General Requirements”
• CSA E60730-2-9 “Automatic Electrical Controls for Household and Similar Use – Part 2-9: Particular Requirements for
Temperature Sensing Controls”
• UL 943 4th ed. “Ground-Fault Circuit Interrupters”
• CSA C22.2 No. 144.1-06 “Ground-Fault Circuit Interrupters”
Membrane
DITRA-HEAT:
• ICC-ES Report No. ESR-2467
• ICC-ES PMG Report No. PMG-1204
• U.S. Pat. No. 8,950,141, and U.S. DES. PAT. No. D706459
Canada D Schluter Systems L.P. and other patents pending
DITRA-HEAT-TB:
• ICC-ES Report No. ESR-2467
• ICC-ES PMG Report No. PMG-1204
• Patent pending
Green Building
DITRA-HEAT has been independently tested for VOC emissions per California Specification 01350: “Standard Practice for the Testing of
Volatile Organic Emissions from Various Sources Using Small-Scale Environmental Chambers”.
DITRA-HEAT was found to emit 0.03 mg/m
3
total VOCs. Thus, DITRA-HEAT complies with tolerable levels outlined in CA 01350. Products
in compliance with the tolerable levels outlined in this specification are specified by many green building standards and rating systems,
including:
• LEED v4, IEQ Credit: Low-Emitting Materials
• NAHB National Green Building Standard (ICC 700), 901.7, 901.8: Pollutant Source Control - Hard-Surface flooring, Wall coverings
• Green Globes for New Construction 2014 (v1.3), 3.7.1: Volatile Organic Compounds
• International Green Construction Code (IgCC), 806.4, 806.5: Flooring, Wall Systems
• Standard for the Design of High Performance Green Buildings (ASHRAE 189.1), 8.4.2.3, 8.4.2.6: Floor Covering Materials, Wall
Systems
• California Green Building Standards Code (CALGreen), 4.504.2 (Res), 5.504.4 (Non-Res): Finish Material Pollutant Control
• CHPS, EQ2.2: Low-Emitting Materials
Property Test Method Performance
VOC emissions CA 01350 and ASTM D5116 0.003 mg/m
3