Instructions / Assembly

10 11 12 13 14 15 16 17 18
APPLE HOME
Controlling this HomeKit-enabled accessory
automatically and away from home requires a
HomePod, HomePod mini, or Apple TV set up as a
home hub. It is recommended that you update to the
latest software and operating system.
To control this HomeKit-enabled accessory, the
latest version of iOS or iPadOS is recommended.
NOTES:
CONNECTING THE
DITRA-HEAT-E-RRS
POWER MODULE(S)
GROUND FAULT PROTECTION
The thermostat is equipped with a ground fault
protection that can detect a current leakage of
5 mA. When a current leakage is detected, the ground
fault protection is triggered and quickly interrupts the
power supply to prevent any serious injuries.
Testing the ground fault protection:
This thermostat has an Auto Test which periodically
verifies the correct operation of the protection circuit.
You can also do this manually:
1) Press the TEST button.
Note: If the RESET button’s red warning light does not
turn ON, the test has failed. Turn OFF the power to the
heating system from the main electrical.
2) Press the RESET button to restart the thermostat’s
base
DISCONNECTING THE
THERMOSTAT FROM THE
ROUTER OR FROM THE APP
Tap the two arrows ( ) simultaneously to
enter the connection menu. In the connection menu,
hold the two arrows until “Disconnected” is displayed.
.
LEAVING THE STANDBY MODE
When the thermostat is on standby, press any button
to turn back ON the thermostat. The thermostat will
resume operation under its last program settings. A
thermostat that is placed on standby before a power
failure will be on standby by default when power is
restored.
TROUBLESHOOTING
CHECK FLOOR SENSOR: Signifies that the
thermostat is in floor heating mode and there is no
floor temperature sensor connected to it.
GFCI FAULT: Signifies there is a short-circuit above
maximum level with at least one conductor.
NETWORK NOT FOUND: Signifies the SSID
network can’t be found.
INCORRECT PASSWORD: Signifies the password
is incorrect.
Schluter
®
-DITRA-HEAT
Thermostat
3-Year Limited
Warranty
Visit www.schluter.com
for warranty information.
TECHNICAL SPECIFICATIONS
Operating voltage:
120/208/240 Vac, 50/60 Hz
Maximum load:
1800 W @ 120 V / 15 A, max.
3120 W @ 208 V / 15 A, max.
3600 W @ 240 V / 15 A, max.
Setpoint range:
5° C to 36° C (41° F to 97° F)
Display range:
0° C to 50° C (32° F to 122° F)
Resolution:
± 0.5° C (± 1° F)
Storage:
-20° C to 50° C (-4° F to 122° F)
Auxiliary output:
24 Vac/Vdc 0.1 A
GFCI protection:
Class A (5 mA)
Protocol:
Wi-Fi Standard: IEEE 802.11 b/g/n Frequency: 2.4 GHz
FCC License:
2AC7Z-ESPWROOM32
IC License:
21098-ESPWROOM32
Certifications:
under the following safety standards:
UL 60730-1, UL 60730-2-9, UL 943,
CAN/CSA E60730-1, CAN/CSA-E60730-2-9, CSA C22.2 No.144.1
USA - Design patent pending
Canada – Industrial design pending
© 2022 Schluter Systems L.P. and affiliates. All Rights Reserved.
DITRA-HEAT-E-RRS
DITRA-HEAT-E-RRS DITRA-HEAT-E-RS1
OTHER
DITRA-HEAT-E-RSS
Item: 660-0740-0000
Schluter Systems L.P.
194 Pleasant Ridge Road, Plattsburgh, NY 12901-5841
Tel.: [phone] • Fax: [phone]
Schluter Systems (Canada) Inc.
21100 chemin Ste-Marie, Ste-Anne-de-Bellevue, QC H9X 3Y8
Tel.: [phone] • Fax: [phone]
www.schluter.com
When requiring more than 15 amps in a room, the
Schluter
®
-DITRA-HEAT-E-RRS power module is
recommended. This power module is the only model
which can be used with the Schluter
®
-DITRA-HEAT-
E-RS1 Smart Thermostat.
FACTORY RESET
To perform a reset of all parameters to the factory
default: Press the dot soft button for one second
and press it again repeatedly until reaching the
diagnostic page. From the diagnostic menu, hold the
up and down arrow ( ) simultaneously for 10
seconds. Select “Yes” using the arrows, and confirm
by pressing the dot soft button.
FIRMWARE VERSION
To obtain the version of the firmware installed
into the thermostat: Press the dot soft button
for one second and press it again repeatedly until
reaching the diagnostic page.
Use of the Works with Apple badge means that an accessory has been designed to work
specifically with the technology identified in the badge and has been certified by the developer
to meet Apple performance standards. Apple is not responsible for the operation of this device
or its compliance with safety and regulatory standards.
Apple, Apple Home, HomeKit, HomePod, HomePod mini, iPad, iPhone, Siri and Apple TV are
trademarks of Apple Inc., registered in the U.S. and other countries and regions. App Store is a
service mark of Apple Inc., registered in the U.S. and other countries.
Amazon, Alexa and all related logos are trademarks of Amazon.com, Inc. or its affiliates.
Google, Android and Google Play are trademarks of Google LLC..
The Wi-Fi CERTIFIED™ Logo is a certification mark of Wi-Fi Alliance
®
IC
This device complies with Industry Canada license exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device does not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
FCC
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment OFF and ON, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Re-orient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.