Shower Installation Guide

16 INSTALLATION — Drain Adaptor Kit Assembly
INSTALLATION
Drain adaptor kit assembly
Please refer to the Schluter
®
-Systems installation video in addition to reading the instructions below.
Remove clamping ring from installed drain. Save the bolts for
installation of the adaptor ring.
1
Align the bolt pattern of the clamping ring with the matching punch-
outs in the adaptor ring. Punch the matching inserts out through the
stainless steel adaptor ring.
2
Apply a continuous 1/4" - 3/8" (6 mm - 10 mm) bead of Schluter
®
-
KERDI-FIX to the installed drain flange.
3
Align the holes in the adaptor ring with the bolt holes in the installed
drain and place the adaptor ring on the installed drain flange.
Re-insert bolts.
4
Bolts are to be finger-tight plus 1/4 turn. Do not overtighten,
as this may warp the adaptor ring and result in leaks. Use star
pattern when tightening bolts.
5
Slide adaptor flange into adaptor ring. Ensure full support under the
adaptor flange with mortar or foam tray center section and thin-set
mortar (not shown).
6
Note: When ready to set tiles, snap grate into height adjustment collar, butter underside of grate with thin-set mortar and slide assembly into adaptor
flange. Install surrounding tiles and press grate flush with tile surface.