Installation Guide

Remove the clamping ring from the installed

drain and save the bolts. Align the bolt

pattern of the clamping ring with the adaptor

ring and punch the matching inserts through

the adaptor ring.

Apply a continuous 1/4" - 3/8" (6 mm - 10

mm) bead of KERDI-FIX to the installed

drain flange. Place the adaptor ring on

the installed drain, re-insert the bolts, and

tighten evenly. Make bolts finger-tight plus

1/4 turn; over tightening may warp the ring

and result in leaks.

Slide the adaptor flange into the adaptor ring

and ensure full support under the adaptor

flange with mortar. The mortar bed is then

placed according to the instructions on

page 25.

Note: For the KERDI-DRAIN 7-1/2" Adapter

Kit, the extended adapter bonding flange

may be cut to length.

Clamping Ring Drain Installed: If a clamping ring drain is installed, replace with KERDI-DRAIN or convert using the KERDI-DRAIN adaptor kit.

Note: Schluter

-Systems strongly recommends a leak test be performed on the

connection between the drain and the waste line prior to continuing with the

remainder of the installation whenever possible. Refer to local plumbing and/or

building codes for any speciﬁc requirements in your area.

26 SPACER SELECTION