Installation Guide

Measure and cut the channel and grate
to the desired length so that the drain
opening is positioned over the flange
opening, making sure to leave a 1/16" - 1/8"
(1.5 - 3 mm) joint between the channel and
the tile. For example, if the channel is to be
36" (91 cm) long and the flange opening is
centered, cut 6" (152 mm) from both ends of
48" (122 cm) channel and grate.
Note: The shortest allowable length to cut
the channel and grate is 10" (25.4 cm).
Caution: The cut ends may be jagged or
sharp; use a metal file to remove any burrs
or sharp edges. Utilize applicable safety
equipment and use care when making cuts.
See the Cutting KERDI-LINE-VARIO section
for additional guidance.
Dry fit and mark where the channel will be
placed. Then, install a row of tile adjacent
to the channel position on the shower floor
using thin-set mortar.
Install remaining tile. Grout and clean up.
Insert the grate into the channel.
12
15
18
Press the stainless steel end cap(s) to the
cut end(s) of the grate. Note: End caps
are compression fit and do not require any
adhesive to install.
13
Using a notched trowel, liberally apply thin-
set mortar to the substrate and to the back
side of the channel. Schluter SET
®
, ALL-SET
®
,
FAST-SET
®
, or unmodified thin-set mortar will
be used to adjust to the required height of
the channel to accommodate the thickness
of the tile.
16
Embed the channel into the thin-set mortar
until it is flush with or slightly lower than the
adjacent tile. Check to ensure the channel is
level and the 1/16" - 1/8" (1.5 mm - 3 mm) gap
is accommodated for along the perimeter.
17
Center and attach the black downspout to
the bottom of the channel using the provided
two-sided tape.
14
Cutting KERDI-LINE VARIO
Observe all safety instructions and standards as directed by the cutting tool manufacturer
including protective eyewear, hearing protection, and gloves. Always measure carefully
and dry fit the channel and grate after cutting to ensure proper fit and alignment prior to
installation.
KERDI-LINE-VARIO may be cut using the following options:
• Variable-speed angle grinder set to a medium-low speed using the Schluter
®
-
PROCUT-TSM cutting wheel or alternative cutting wheel suitable for stainless steel.
• Band saw with a blade suitable for cutting stainless steel.
• Hack saw with a blade suitable for cutting stainless steel.
Caution: Regardless of the cutting tool used, the cut end(s) may be jagged or sharp.
Remove any burrs with a metal file, or similar, before installing the end cap(s).
36 INSTALLATION — Schluter
®
-KERDI-LINE-VARIO
Channel and Grate