Installation guide

LTU/NTU SZ-DOC-W5-1.pd

Operating Manual

ersion: 1.5

Revision: 2002-09-10 2

1.1 Important Safeguards

This section describes the safety precautions the user should abide by when operating this

equipment.

• Transport this equipment in its original packaging or by using appropriate materials to

prevent against shock and impact.

• Before setting up this product for operation please make note of the accompanying

environmental requirements.

• Slots and openings in the unit are provided for ventilation. To ensure reliable operation and

to protect it from overheating these slots and openings must not be blocked or covered.

• Condensation may occur externally or internally if this equipment is moved from a colder

room to a warmer room. When moving this equipment under such conditions, allow ample

time for the equipment to reach room temperature and to dry before operating.

• Note that normal operation (in accordance with EN 60950) is only possible when the

external housing is left in place (ventilation, fire prevention, and radio interference).

• Before supplying power, verify the power rating identified on the marking labelcomplies

with the local power source.

• Do not allow anything to rest on any of the attached cables and do not locate the product

where persons will walk or trip on the cables.

• Connect this equipment only to an approved, properly grounded, and accessible socket

outlet. To completely turn off this equipment you must remove the power cord from the

system.

• Avoid connecting or disconnecting data lines during lightning storms.

• Follow the accompanying instructions when connecting the required cabling.

• Make sure no foreign objects or liquids come into contact with the internal components

(danger of shock or short circuit).

• In an emergency (e.g., damaged external housing or internal elements, liquid spills) im-

mediately remove the power cord and notify customer service.

• Electrostatic electricity can damage internal components. Ground yourself before touching

any internal components.

• Never use water to clean this device. If water reaches the internal parts, extreme danger

may result to the user or the equipment.

• Never use scouring or abrasive cleaning agents, or agents containing alkaline on device.

Damage of the device‘s exterior may result.