Installation guide

SZ-DOC-W5-1.pdf LTU/NTU
Version: 1.5 Operating Manual
51 Revision: 2002-09-10
Note:
Upper window (LTU-A, LTU-B lines) contains local, lower window (NTU-A, NTU-B lines) contains
remote diagnostic information
The Slave displays only local information
In case of a NTU-NTU or LTU-LTU connection, the unit designators are changed accordingly
The DIAGNOSTIC command is available at menu levels 1-4, the help information is only
displayed at level 2
The DIAGNOSTIC command is READ only.
7.3.3.2 STATUS Command
The STATUS command displays the actual system status:
LTU_01_FMM> STATUS
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Local System Status V1.4
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
SYNC-A: 00 OPS-A: 10 PID-A: 00 PWR-A:+00.00 GAIN-A:+00.00
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
LTU_01_FMM>
Definitions:
Parameter Status Meaning
SYNC
00
01
02
03
04
05
06
07
Status of SHDSL synchronization state machine of loop A
according to ETSI TS 101 524.
Out of Sync State
State 0
In Sync State
State 1
State 2
State 3
State 4
State 5
OPS
00
01
10
18
80
Operational mode of the transceiver
Idle Mode
Data Mode
Startup handshake in progress
Startup training in progress
Local analog loopback
PWR n Transmit power of each channel [dBm]
GAIN n Receiver Gain [dB]
PID-A n Pair Identification when 4p operation is enabled