Installation guide

LTU/NTU SZ-DOC-W5-1.pd
f
Operating Manual
V
ersion: 1.5
Revision: 2002-09-10 58
7.3.3.14 RESETCARD Command
Upon execution of the RESETCARD command the screen comes as follows:
LTU_01_FMM> RESETCARD
*** Warning: this command will reset both SHDSL links of the Dual LTU
enter reset command again to confirm (timeout after 30 sec)
LTU_01_FMM>
LTU_01_FMM> RESETCARD
46:35:30 reset command confirmed
46:35:30 system reset
7.3.4 Configuration Management CM
02:26:00 Configuration management activated
Type <M> to return to MAIN, or <H> for HELP information
Type <H> and the monitor lists all available commands in the configuration sub-menu:
LTU_01_CM> H
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
CONFIG Display local configuration
G704 [ON,OFF] Set framed mode / transparent mode
CRC4 [ON,OFF] Set CRC4 mode on/off
EBIT [ON,OFF] Set automatic E-Bit insertion on/off
AISGEN [ON,OFF] Set AIS generation on/off
AISDET [ON,OFF] Set AIS detection on/off
EXTCLK [ON,OFF] Set external clock mode on/off
MP Display E1 time slot map
MP [0..3] Set E1 time slot mapping mode
TS [0..3] Select number of time slots
UIF type Select user interface type
MASTER [ON,OFF] Set SHDSL master mode / slave mode
POWER [ON,OFF] Set remote powering on/off
RESTART [ON,OFF] Set autorestart on/off
BACKOFF [ON,OFF] Set power backoff on/off
MODE [1,2] Set SHDSL operating mode
DEFAULT [0..2] Set default configuration
M(AIN) Return to main menu
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
LTU_01_CM>
Notes:
The MASTER command is available on the LTU-L only (Jumper located on the PCB in position "RPWR
OFF").
The POWER command is available on the LTU-R only (Jumper located on the PCB in position "RPWR ON").
The UIF type command selects only equipped user interfaces.
To display the current E1 time slot mapping mode, enter the MP command without parameter