User guide

Installin
g
and Confi
g
urin
g
the Module
840 USE 115 00 Version 1.0
17
2.2 Installing the Module
The Ethernet web embedded server module comes full
y
read
y
to be installed.
Installation consists of mountin
g
the module on the backplane and connectin
g
the
cable.
2.2.1 Are You Really Ready to Install? Check!
Have
y
ou reviewed the confi
g
uration and network
g
uidelines on pa
g
e 15? You
must meet those
g
uidelines before installin
g
the module.
If you are planning to
change the default configuration, stop the controller before installing the Ethernet
web embedded server module.
Modicon also recommends that
y
ou test to be sure
y
our Ethernet cablin
g
is workin
g
properl
y
before connectin
g
it to the Ethernet module. Some suppliers of testin
g
e
q
uipment are listed in Appendix D.
2.2.2 Mounting the Module on the Backplane
Mount the module at an an
g
le onto the two hooks located near the top of the
backplane. Swin
g
the module down to make an electrical connection with the
backplane I/O bus connector.
Ti
g
hten the screw at the bottom of the module to fasten it to the backplane. The
maximum ti
g
htenin
g
tor
q
ue for this screw is 2-4 in-lbs
(
.23 - .45 Nm
)
.
Figure 10 Mounting an Ethernet Module on the Backplane
I/O Bus
Connector
Module
Hooks