User Manual
Table Of Contents
- RFID OsiSense® XG
- Table of Contents
- Safety Information
- About the Book
- General Information
- Specifications and Physical Description
- Installing the System
- Operating Principles
- EtherNet/IP Communications Support
- Modbus TCP/IP Communications Support
- Web Server
- Diagnostics
- FAQs
- Glossary
- Index
Installing the System DI[D-SE-0029861.1.9]
40 EIO0000001601 Draft 2013/07/17
IP Addres s Configuration
IP Address Configuration
Introduction
IP address: Every item of equipment connected to an Ethernet network must have a unique IP
address. This address makes it possible to refer to a specific unit.
Subnet mask: The subnet mask defines a range of IP addresses that can be accessed from an
item of equipment.
The table describes the standard IP subnet masks:
The table gives an example of accessible address ranges depending on the network class:
NOTE: xxx represents a possible value from 0 to 255.
Address Configuration
The factory default address is 192.168.0.10.
The configuration of the IP address is made by setting parameters in the web server embedded in
the Smart Antenna to:
” manually set the IP address,
” automatically get an IP address from the DHCP server.
Network Class Host Bits Subnet Mask
A 24 255.0.0.0
B 16 255.255.0.0
C 8 255.255.255.0
Network Class Addresses Accessible Addresses
Ranges
B IP: 192.168.0.1
Mask: 255.255.0.0
IP: 192.168.xxx.xxx
C IP: 192.168.0.1
Mask: 255.255.255.0
IP: 192.168.0.xxx
NOTICE
UNINTENDED EQUIPMENT DAMAGE
” Do not use factory configured IP address for operation.
” Assign a new IP address for operation.
Failure to follow these instructions can result in equipment damage.