User Instructions

Clipsal® RF Gateway 63249-420-273A3
Instruction Bulletin 02/2009
10
© 2009 Schneider Electric. All Rights Reserved.
Figure 3: Hardware Burden Connection on the Unit
KEY:
A. RJ-45 C-Bus receptacle on the unit
B. Hardware burden
Software Burden
The RF Gateway incorporates a software-selectable network
burden. To enable a software-selectable burden, first install a
hardware burden on the network and then enable the software
burden using C-Bus Toolkit software. After the software burden is
enabled, remove the hardware burden.
C-Bus System Clock
The RF Gateway has a software-selectable C-Bus system clock with
the capability to synchronize data communication on the C-Bus
network. Typically the clock is disabled: Successful C-Bus network
communications require only one active clock. A maximum of three
C-Bus units per network can have the clock enabled. Refer to the C-
Bus Toolkit software for additional information and to enable the RF
Gateway system clock.