User Instructions

63249-420-273A3 Clipsal® RF Gateway

02/2009 Instruction Bulletin

Selecting a Location

It is important to select the right location to install the RF Gateway.

Some considerations are listed below:

 Provide easy access to unit.

 Locate RF Gateway where it will not be subject to water,

humidity, direct sunlight, or heavy dust.

 Do not cover unit.

 Only use RF Gateway indoors.

 Allow adequate ventilation.

 Ensure the Learn button, located on the base of the unit, can be

accessed.

 The unit should be located centrally to other RF Wireless units

so that all units are within range of each other. (See Electrical

Specifications for information on the range.)

 If the installation will use the infrared sensor feature, place the

unit in a location that allows the infrared receiver to be visible.

Avoid obstructions that might impede infrared signals coming

from a remote control.

CONFIGURATION AND PROGRAMMING

Before using the RF Gateway, connect it to a C-Bus wireless and

wired network. Connect to a wireless system using learn mode.

Connect to a wired network using the C-Bus Toolkit software.

Connecting to a RF Wireless Network

To link the RF Gateway to a Clipsal® RF Wireless system:

1. Press the Learn button on the base of the RF Gateway. An

indicator light at the front of the RF Gateway starts flashing

slowly. You now have 3 minutes to complete steps 2 and 3.

2. Press the Learn button on any networked wireless wall unit. The

unit's Learn LED will flash to indicate it is in learn mode.

3. Double press the Learn button on the same wall unit. This

transmits the network address to the RF Gateway. The slow

flashing indicator light on the RF Gateway will flash quickly for

about one second and then turn off to indicate that it has been

linked to the wireless system. The RF Gateway will exit Learn

mode automatically.

4. Press the Learn button on the wall unit to make the wall unit exit

Learn mode.