User Instructions

Clipsal® RF Gateway 63249-420-273A3
Instruction Bulletin 02/2009
12
© 2009 Schneider Electric. All Rights Reserved.
Connecting to a Wired Network
To connect the RF Gateway to a C-Bus wired network:
1. Remove the Wired C-Bus Connection Cover. To do so, first
uninstall the unit (if it has been mounted on the wall) and position
the base of the unit towards you. Push the cover straight up and
out.
Figure 4: Removing the C-Bus Connection Cover
2. To connect the RF Gateway to the wired C-Bus network, plug
the C-Bus cable into either of the RJ45 sockets as described in
Wiring Guidelines and Connection to the C-Bus Network. (The
Figure shows the location of the RJ45 sockets.)
3. Use the C-Bus Toolkit software to configure the wired side of the
RF Gateway as described in Configuration.
4. Align the cover to the Gateway and snap the cover into the
mounting slots on the Gateway.
5. Position the antenna for optimal reception.
Figure 5: RF Gateway: Rear/Top View (cover removed)
KEY:
A. Wired C-Bus
cover mounting
slots
B. RJ45 sockets
C. Antenna