User Instructions

63249-420-273A3 Clipsal® RF Gateway
02/2009 Instruction Bulletin
© 2009 Schneider Electric. All Rights Reserved. 15
Table 2: RJ45 Pin Connections
RJ Pin C-Bus Connection Color
1 Remote ON* Green/White
2 Remote ON* Green
3 C-Bus Neg (-) Orange/White
4 C-Bus Pos (+) Blue
5 C-Bus Neg (-) Blue/White
6 C-Bus Pos (+) Orange
7 Remote OFF* Brown/White
8 Remote OFF* Brown
*Not internally connected.
Configuration
A RF
Gateway consists of two separate internal sub-units, one for
the wired network and one for the wireless system. Several
gateways may be used within a wired C-Bus™ Network installation.
When the installer scans the networks using C-Bus Toolkit software
via a PC Interface, each Gateway identifies itself with one of four
names, depending on its connection type (wired or RF wireless) and
its position in the network (near or far side). See the names in the
figure "Identifying Gateways When Scanning from a PC Interface."
To configure the RF Gateway on a wired network, use C-Bus Toolkit
Software.