User Instructions

Clipsal® RF Gateway 63249-420-273A3
Instruction Bulletin 02/2009
16
© 2009 Schneider Electric. All Rights Reserved.
When configuring the wired side of the RF Gateway, note the
following points.
 The Unit Address of the wired near side of the RF Gateway
(GATEWLSN) must match the Network Address of the
Clipsal RF wireless system being linked to.
 The Unit Address of the wireless far side of the RF Gateway
(WGATE5F) must match the Network Address of the C-Bus
wired network being linked to.
The figure is a diagram of an installation with two wired networks
linked through a wireless system. The installation uses two
Gateways. Four Gateway subunits show up if the installer scans the
networks using C-Bus Toolkit software via the PC Interface (PCI).
Figure 7: Identifying Gateways When Scanning from a PCI