User Instructions

63249-420-273A3 Clipsal® RF Gateway
02/2009 Instruction Bulletin
© 2009 Schneider Electric. All Rights Reserved. 17
Communication Options
The RF Gateway supports explicit routing of messages into and
through both C-Bus™ wired networks and Clipsal® RF wireless
systems. Such messages are used by control software such as the
C-Bus Toolkit and control units such as the C-Touch Color Touch
Screen.
Several options are available when using the C-Bus Toolkit software
to edit the Gateway unit. The following options are included on the
"Connections" tab:
 Send to adjacent network - This causes standard messages
(such as button presses) on either side of the specified "Connect
Applications" to be sent to the adjacent wired network or wireless
system. When this option is enabled, a unit with a specific Group
Address on the one side of the Gateway will be associated with
units with the same Group Address on the other side (if units
have the same Application Address).
 Send to other remote network - This allows standard messages
on either side of the specified "Connect Applications" to be sent
from the wireless system to a non-adjacent C-Bus network
(possibly through one or more network bridges).
 Synchronize to wired - This option applies when the Gateway is
powered up. It causes the Gateway to retrieve the levels of
groups in the wired C-Bus network, and set the levels of
corresponding groups in the wireless system to the same values.