User Instructions

Table Of Contents

63249-420-278A3 Clipsal® RF Remote Control

02/2009 Instruction Bulletin

PROGRAMMING THE REMOTE

Follow the guidelines below to make the Remote Control functional.

 Program C-Bus Wireless units to recognize the remote's buttons.

 Program the remote, wall units, and plug adapter units using

learn mode.

Learn mode is activated on the remote by removing the back cover

(see the "Installing the Batteries" section to removing the back

cover), and sliding the switch up to the Learn position. Refer to the

steps below to activate learn mode.

Use the following procedure to assign a button on the remote to a

button on a C-Bus Wireless wall unit or plug adapter unit:

NOTE: Assigning a button on the remote to a button on a C-Bus

Wireless unit does not unlearn previous assignments to other units.

To do this, follow the instructions in the "Clearing Remote

Assignments" section.

1. Set the C-Bus Wireless RF Remote Control to learn mode by

sliding the switch across to the Learn position. A book icon is

displayed on the remote's screen when learn mode is activated.

2. On the wall unit, press the Learn button to activate learn mode.

3. On the remote, press the button you want to assign. The

indicator lights on the remote will flash.

4. Quickly press the button on the wall unit you want the remote to

control (within 30 seconds of pressing the remote button while

the indicator lights are flashing).

NOTE: All units on the network will enter Learn mode at this

time.

5. Repeat steps 3 and 4 to program additional buttons.

6. When you have finished programming remote buttons, press the

learn button on the wall unit to exit learn mode.

7. Slide the learn mode switch on the back to the Use position.