User Instructions

Clipsal® RF Remote Control 63249-420-278A3
Instruction Bulletin 02/2009
6
© 2009 Schneider Electric. All Rights Reserved.
Figure 1: Side and Front View of the Remote Control Holder
The Remote Control Holder is fixed to a surface using screws or
double-sided adhesive mounting pads.
To attach the holder using mounting pads:
1. Peel off the backings from of one side of the mounting pads.
2. Stick the four mounting pads along the "T" on the back of the
holder.
3. Peel off the backings from the other side of the mounting pads
and press the holder firmly against the wall.
To attach the holder with screws:
1. Gently push the sides of the holder out to remove the cradle
section. Refer to the "Removing the Cradle Section" figure.
2. Place one hand on each end of the holder's base. Gently bend
the base until the T section pops out. Refer to the "Removing the
'T' Section" figure.