User Instructions

63249-420-278A3 Clipsal® RF Remote Control
02/2009 Instruction Bulletin
© 2009 Schneider Electric. All Rights Reserved. 7
Figure 2: Removing the Cradle Section
Figure 3: Removing the 'T' Section
3. Hold the T section against the mounting surface and use a pencil
to mark the position of the holes on the mounting surface.
4. Drill the holes. (Use a 2mm drill bit for wood, or use a 6.5mm
masonry bit when using wall plugs.)
5. Insert the wall plugs (if used). Place the T section against the
mounting surface with the countersunk side visible. Screw the T
section to the surface.
6. Press the remaining base section onto the T section until it
snaps into place.
7. Place the cradle section against the mounting surface (just
below the base). Slide the cradle up so that the bottoms of the
cradle and base sections meet. Push the sides of the cradle
section so they snap into the base.