User manual

PROGRAMMING Menu
SR2MAN01 11/2007 47
Entry of Function Block Parameters
Description
When entering a control diagram, the parameters of the configurable automation
functions must be completed.
The automation functions with parameters are the following:
z Auxiliary relays (see Auxiliary Relays, p. 93) (latching),
z Discrete Outputs (see Discrete (DISCR) Outputs, p. 98) (latching),
z Clocks (see Clocks, p. 134),
z Analog Comparators (see Analog Comparators, p. 129),
z Timers (see Timers, p. 101),
z Counters (see Counters, p. 111),
z Fast counters (see Fast Counter, p. 118).
Accessibility of
parameters
Function block parameter setting can be accessed:
z When entering the command diagram line,
z From the PARAMETERS menu if the block has not been padlocked.
Note: Accessible only in LD mode / smart relay in STOP mode.